|
|
Post by ALADKINS on Dec 22, 2004 9:33:21 GMT -5
I'm new here... but what oil ratio do you guys use. any type
|
|
|
|
Post by TheNoisePolluter on Dec 22, 2004 9:42:12 GMT -5
first welcome to vizas discusstion board.
i use 40:1 non synthetic
|
|
|
|
Post by NHCA on Dec 22, 2004 21:05:28 GMT -5
Use 40:1 for the gas/oil ratio with either synthetic or regular 2-stroke oil.
|
|
|
|
Post by Brandon R on Dec 27, 2004 22:13:24 GMT -5
i got a v2 and i use 50:1 w/ stil 2-stroke oil and yeah welcome 2 the disscusion board ;D
|
|
|
|
Post by Trick Worm on Dec 27, 2004 22:57:02 GMT -5
wellcome to the disscusion board i use 40:1 with two stroke oil
|
|
|
|
Post by Brandon R on Jan 1, 2005 11:13:27 GMT -5
lol i meant STIHL lol
|
|
|
|
Post by TheNoisePolluter on Jan 13, 2005 22:48:36 GMT -5
I use opti-2 cycle oil, it works with any ratio because its by how hot the engine runs not by the amount needed and you only put in 1.8 oz per gallon and that will give you really good over all performance, and it causes no build up, no smoke and the thing I like about it is you can barley smell the exhaust, but its expensive and hard to find.
|
|
|
|
Post by gascooter on Jul 8, 2005 22:57:11 GMT -5
I have the V2 for my daughter. Are you saying that you run 50:1 ratio event though the manual says 32:1. I do think that would eliminate alot of smoke and smell, but will it hurt the engine.
Thanks
|
|
|
|
Post by Brandon R on Jul 9, 2005 20:38:33 GMT -5
well, i have a Mitsubishi TLE-43 engine on mine, the keyang runs a different ratio
|
|
|
|
Post by Brandon R on Jul 13, 2005 11:06:24 GMT -5
run what the maual says to
|
|
|
|
Post by Trick Worm on Jul 13, 2005 16:40:49 GMT -5
what does the manual say 50:1?
|
|
|
|
Post by Brandon R on Jul 13, 2005 20:15:32 GMT -5
well the VIZA MOTORS one says 32:1 but my specific engine manual that came with it said 50:1 so i use 50:1 but you can use 40:1 or 32:1 it doesnt matter but the lower the number the more oil is used with the gallon of gas
|
|
rentyman
Full Member
Lord of the Vahnatai
Posts: 142
|
Post by rentyman on Sept 24, 2005 18:25:39 GMT -5
i just fill the bottom of a small gas tank of synthetic oil and fill rest with gas for my V2, and give it a few extra turns on the gas control screw to allow for a little faster speed.
if ur engin makes weird sounds at full throt, then turn it back half a turn til it sounds good. then turn the screw on top of carb down til it idles good, too much will give u poor gas milage, too little will cut engin
|
|
